|
|
|||||||
| SageTV Software Discussion related to the SageTV application produced by SageTV. Questions, issues, problems, suggestions, etc. relating to the SageTV software application should be posted here. (Check the descriptions of the other forums; all hardware related questions go in the Hardware Support forum, etc. And, post in the customizations forum instead if any customizations are active.) |
 |
|
|
Thread Tools | Search this Thread | Display Modes |
|
#1
12-30-2006, 09:52 PM
|
|||
|
|||
|
Unlinking all Infrared commands
I have all sorts of unknown and test only Infrared commands I want to remove so I can start over with a clean slate. The problem with the unlinking utility is that you need to know the Infrared button to push in order to unlink it and I dont know what some of them are. Unlinking a keyboard command is no problem because you can see what thay are in plain english. Can this be done?
Thanks 
|
|
#2
12-30-2006, 10:26 PM
|
||||
|
||||
|
Edit the properties file and remove all the ui/rc_mappings/<command name here>=#### lines.
- Andy
__________________
SageTV Open Source v9 is available. - Read the SageTV FAQ. Older PDF User's Guides mostly still apply: SageTV V7.0 & SageTV Studio v7.1. - Hauppauge remote help: 1) Basics/Extending it 2) Replace it 3) Use it w/o needing focus - HD Extenders: A) FAQs B) URC MX-700 remote setup Note: This is a users' forum; see the Rules. For official tech support fill out a Support Request.
|
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Linear Mode
