|
|
|||||||
| SageTV Software Discussion related to the SageTV application produced by SageTV. Questions, issues, problems, suggestions, etc. relating to the SageTV software application should be posted here. (Check the descriptions of the other forums; all hardware related questions go in the Hardware Support forum, etc. And, post in the customizations forum instead if any customizations are active.) |
 |
|
|
Thread Tools | Search this Thread | Display Modes |
|
#1
12-27-2006, 12:43 PM
|
|||
|
|||
|
What is going on with standby?
I have just loaded a fresh OS (XP) and loaded up sagetv. I'm using a MCE remote. The remote works just fine. But when I press the PC button on the remote to put the system into standby. the system will not power off. It does shutdown some what, the video goes dead, sounds like the drives power down though. But, the power supply still runs and the fans are running internal.
How do I get the system to fully power off. I've checked everything and can't find why. Thanks
__________________
SageTv server: 2008 64 BIT R2, Asus MN2-E, AMD dual core 4200, 4gb ram, Promise raid 5 8TB, 80gb Sata boot drive w/OS, 2/ dual tuner HDhomeruns, HD-PVR 3/HD-100's, 1/HD-200 
|
|
#2
12-27-2006, 03:37 PM
|
||||
|
||||
|
Check your BIOS power saving settings. You need to set the sleep mode to S3 instead of S1.
__________________
Intel NUC SageTV 7 server - HDHomeRun PRIME - 2TB iSCSI ReadyNAS storage Intel i3 HTPC SageTV 7 Client - Win 7 x64 - Onkyo TX-674
|
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Linear Mode
