|
|
|||||||
| SageTV Software Discussion related to the SageTV application produced by SageTV. Questions, issues, problems, suggestions, etc. relating to the SageTV software application should be posted here. (Check the descriptions of the other forums; all hardware related questions go in the Hardware Support forum, etc. And, post in the customizations forum instead if any customizations are active.) |
 |
|
|
Thread Tools | Search this Thread | Display Modes |
|
#1
11-13-2006, 10:24 PM
|
|||
|
|||
Problem with SageTV 5.0.4.92
Hi,
I have two versions of SageTV installed on my PC, 4.x and 5.0.4.92. I'm still using STV4 because I have a 'No signal' problem with the STV5. When I'm recording the channel 35, and watching it at the same time because I only have one tuner in my PC, STV is always freezing for at least the first five minutes of the recorded show and it shows the 'No signal' notification until the end of these five minutes. It's always five minutes and few seconds. I don't have any record padding configured and I don't have this problem with STV4. Even if I change the channel and get back to the channel 35, it shows 'No signal' until the five minutes period ends. Can this problem be an error in the tv listing provided by Zap2It? Weird problem. 
|
|
#2
11-13-2006, 10:45 PM
|
||||
|
||||
|
__________________
SageTV Open Source v9 is available. - Read the SageTV FAQ. Older PDF User's Guides mostly still apply: SageTV V7.0 & SageTV Studio v7.1. - Hauppauge remote help: 1) Basics/Extending it 2) Replace it 3) Use it w/o needing focus - HD Extenders: A) FAQs B) URC MX-700 remote setup Note: This is a users' forum; see the Rules. For official tech support fill out a Support Request.
|
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Linear Mode
