|
|
|||||||
| Hardware Support Discussions related to using various hardware setups with SageTV products. Anything relating to capture cards, remotes, infrared receivers/transmitters, system compatibility or other hardware related problems or suggestions should be posted here. |
 |
|
|
Thread Tools | Search this Thread | Display Modes |
|
#1
10-24-2006, 03:54 PM
|
|||
|
|||
|
Getting pvr-150 remote/blaster to change channels on settop?
Thats pretty much my question, how can I get the pvr-150 remote/blaster to change the channels via the settop box in sagetv. As changing channels with it now in sagetv changes the channel to snow.
Any help would be appreciated. 
|
|
#2
10-24-2006, 08:56 PM
|
||||
|
||||
|
The end of Appendix F in the SageTV manual should have a short blurb about this -- you'll need to configure the IR blaster using the Hauppauge software. Then, during Source Setup for the tuner, you'll be able to choose the Hauppauge IR Blaster as the Tuning Plugin.
If your STV isn't an option in the IR blaster config software, then you'll probably need to contact Hauppauge to look into that further. - Andy
__________________
SageTV Open Source v9 is available. - Read the SageTV FAQ. Older PDF User's Guides mostly still apply: SageTV V7.0 & SageTV Studio v7.1. - Hauppauge remote help: 1) Basics/Extending it 2) Replace it 3) Use it w/o needing focus - HD Extenders: A) FAQs B) URC MX-700 remote setup Note: This is a users' forum; see the Rules. For official tech support fill out a Support Request.
|
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Linear Mode
