Missing lower channels

[reboot_this]

I just upgraded to the new v6 beta and now I am missing a lot of my lower channels. This was not this way before (previously had 2.2.2 installed)

It seems, now, when I disable one of the upper channels the lower "mirror" channel shows up in the lower channels... for example channel 5 is KXAS but so is channel 362... sooo if 362 is enabled channel 5 disappears from the program guide but as soon as I disable channel 362... channel 5 reapperars in the program guide.

I want it the way it used to be where I just disabled certain channels (ie shopping channels) and ALL the rest of the other channels showed up.

Is there a setting that I can change in the properties file to correct this? BTW I only used my wiz.bin and wiz.bak files when I upgraded so I could clear out all of the cayars stv stuff and start with fresh properties files if that helps troubleshoot was happened with channels disappearing all of the sudden.

Thanks in advance to all

[Opus4]

I think what is happening is that networks on multiple channels are getting grouped together, as described on p. 42 of the v6 manual. I don't know why this version is showing them under different channel numbers than your previous version, but as long as the channels are enabled in Channel Setup, they are actually available.

- Andy

[reboot_this]

Originally Posted by Opus4

I think what is happening is that networks on multiple channels are getting grouped together, as described on p. 42 of the v6 manual. I don't know why this version is showing them under different channel numbers than your previous version, but as long as the channels are enabled in Channel Setup, they are actually available.

- Andy

My scheduled recordings on those missing channels (set up before the upgrade) were not showing up in the "recoding schedule" until I disabled the uper channels so the lower channels could show up... I would just rather "see" ALL the channels that I set up in the source setup!

Is there any property to force all the channels to show up? I looked in the manual to try to find a configurable property to "ungroup the network channels", but no luck

I wouldn't mind this happening so much if it were the lower channels (4, 5, 8, 11, etc) that were showing up and the upper channels went missing.

I scoured the properties files all night looking for a fix, but no luck... I did find a property that showed "... unavailable_channel_nums=..." Is this property similar to the ignore encoders that can be cleared while sage is completely off to reset that property?