|
|
|||||||
| SageTV Software Discussion related to the SageTV application produced by SageTV. Questions, issues, problems, suggestions, etc. relating to the SageTV software application should be posted here. (Check the descriptions of the other forums; all hardware related questions go in the Hardware Support forum, etc. And, post in the customizations forum instead if any customizations are active.) |
 |
|
|
Thread Tools | Search this Thread | Display Modes |
|
#1
10-01-2006, 08:37 AM
|
|||
|
|||
Skipping at end of recording
The last couple of recordings I have watched have displayed some very odd symptoms.
I recorded a show that was 2.5 hours long, and it was set to record an extra 10 minutes (in the Series settings). As I watch the show, and fast forward through the adverts, you can see (after about an hour and a half or so), that the progress bar on screen shows that I am almost at the end of my 2.5 hour show. Then, when it gets to the 2.5 hour mark, it starts skipping to catch it self up. And then I see the last hour in about 30 seconds. This has only started happening in the last couple of days, and I have not changed the drivers for my tuner card, changed my Sage Install, I haven't even installed any windows updates and rebooted. I'm about to do a disk check after posting this (requires a reboot as the drive is in use  ), but I was wondering if anyone else has had this issue, and if they had any results in troubleshooting it. I am running SageTV 5.0.4.92, with a Hauppauge PVR 150. Thanks
|
|
#2
10-03-2006, 08:18 AM
|
|||
|
|||
|
Aha, apparently a) no one else has, and b) I'm an idiot.
I have diskeeper installed, and it was running around the same time my recordings were ending (i.e. the last hour or so). So defragging while recording = bad mmkay?
|
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Linear Mode
