|
|
|||||||
| SageTV Software Discussion related to the SageTV application produced by SageTV. Questions, issues, problems, suggestions, etc. relating to the SageTV software application should be posted here. (Check the descriptions of the other forums; all hardware related questions go in the Hardware Support forum, etc. And, post in the customizations forum instead if any customizations are active.) |
 |
|
|
Thread Tools | Search this Thread | Display Modes |
|
#1
07-07-2006, 07:59 AM
|
|||
|
|||
|
Delete Linked Commands
I am sure there is a way to do this just don't know how. I would like to delete all my linked infared commands and start all over. Is there a way to delete them in a file or something instead of going throught each one in the setup screens. Thanks
Glenn Thibeault 
|
|
#2
07-07-2006, 10:13 AM
|
||||
|
||||
|
In the properties file, delete all the ui/rc_mappings/<command name> properties.
- Andy
__________________
SageTV Open Source v9 is available. - Read the SageTV FAQ. Older PDF User's Guides mostly still apply: SageTV V7.0 & SageTV Studio v7.1. - Hauppauge remote help: 1) Basics/Extending it 2) Replace it 3) Use it w/o needing focus - HD Extenders: A) FAQs B) URC MX-700 remote setup Note: This is a users' forum; see the Rules. For official tech support fill out a Support Request.
|
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Linear Mode
