|
|
|||||||
| Hardware Support Discussions related to using various hardware setups with SageTV products. Anything relating to capture cards, remotes, infrared receivers/transmitters, system compatibility or other hardware related problems or suggestions should be posted here. |
 |
|
|
Thread Tools | Search this Thread | Display Modes |
|
#1
06-19-2006, 03:28 PM
|
|||
|
|||
|
Nasty reboot when trying demo
Obtained demo, installed, during initial config wizard in Sage when it gets to the video test after the PCR board selection screen the blue screen of death pops up with as much as I can get says "driver unloaded without cancelling [something]," ...beginning physical memory dump, and then reboots.
Tried dumping Java and reinstalling the latest but it continues to happen over and over again. Can't get past that part of the wizard. Would like to try Sage since I have grown tired of WinTV but I can't even get it to a point to try it out. Ready to throw the pc in the bathtub. Help would be much appreciated. System: P4 3.4 1.5 GB RAM 250GB HDD x 8 Win XP Pro SP2 up to date HCW PCR 250 board 
|
|
#2
06-19-2006, 04:53 PM
|
||||
|
||||
|
HCW PCR 250? Do you mean Hauppuage PVR 250? If so, I would try completely removing the driver & reinstalling the latest 250 driver or even a different driver version.
- Andy
__________________
SageTV Open Source v9 is available. - Read the SageTV FAQ. Older PDF User's Guides mostly still apply: SageTV V7.0 & SageTV Studio v7.1. - Hauppauge remote help: 1) Basics/Extending it 2) Replace it 3) Use it w/o needing focus - HD Extenders: A) FAQs B) URC MX-700 remote setup Note: This is a users' forum; see the Rules. For official tech support fill out a Support Request.
|
|
#3
06-19-2006, 05:34 PM
|
|||
|
|||
|
Yes PVR250
Cleared all the drivers, reinstalled, same evil crash at the same point. Very frustrating. Other suggestions?
|
|
#4
06-19-2006, 08:14 PM
|
||||
|
||||
|
I don't know... another guess: an IRQ conflict with the video card that isn't showing up until using 3D Acceleration in SageTV? Perhaps try installing the card on a different PCI slot.
- Andy
__________________
SageTV Open Source v9 is available. - Read the SageTV FAQ. Older PDF User's Guides mostly still apply: SageTV V7.0 & SageTV Studio v7.1. - Hauppauge remote help: 1) Basics/Extending it 2) Replace it 3) Use it w/o needing focus - HD Extenders: A) FAQs B) URC MX-700 remote setup Note: This is a users' forum; see the Rules. For official tech support fill out a Support Request.
|
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Linear Mode
