|
SageTV Software Discussion related to the SageTV application produced by SageTV. Questions, issues, problems, suggestions, etc. relating to the SageTV software application should be posted here. (Check the descriptions of the other forums; all hardware related questions go in the Hardware Support forum, etc. And, post in the customizations forum instead if any customizations are active.) |
|
Thread Tools | Search this Thread | Display Modes |
#1
|
||||
|
||||
Sage error -3, 80070070
Sage failed to record an important favorites show today with the error (3, 0x80070070) capture error.
I have 4 drives available for recording. One is almost full; the others have 200GB free, 85GB free, and 15GB free. My drives are all UNC. After the failure, I performed a record test by manually recording a show. Sage started the recording on the drive with almost no space available. Why would it do that? Within 5 minutes the drive was full. I didn't see a repeat of the error immediately, but after some troubleshooting I suspect the error is raised at the end of the scheduled recording, not at the point in time when the disk becomes full. Why would Sage behave like this and how do I fix it? Thanks |
#2
|
||||
|
||||
It sounds like SageTV doesn't have permission to use the other UNC paths for storing recordings. If using service mode, make sure it is logging in as a user + password, & that user has permission to use those UNC locations.
- Andy
__________________
SageTV Open Source v9 is available. - Read the SageTV FAQ. Older PDF User's Guides mostly still apply: SageTV V7.0 & SageTV Studio v7.1. - Hauppauge remote help: 1) Basics/Extending it 2) Replace it 3) Use it w/o needing focus - HD Extenders: A) FAQs B) URC MX-700 remote setup Note: This is a users' forum; see the Rules. For official tech support fill out a Support Request. |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|