|
|
|||||||
| Hardware Support Discussions related to using various hardware setups with SageTV products. Anything relating to capture cards, remotes, infrared receivers/transmitters, system compatibility or other hardware related problems or suggestions should be posted here. |
 |
|
|
Thread Tools | Search this Thread | Display Modes |
|
#1
06-04-2006, 10:55 PM
|
|||
|
|||
Using USB-UIRT to recieve and send
Maybe this is a dumb question but is it possible to use the USB-UIRT to both recieve from my remote control and send the commands to my DishTV reciever. I can't seem to figure out how to make it work. When I pick the opion in setup all I get is the capability to control a DirectTV box via serial cable. Thanks for the help
|
|
#2
06-05-2006, 08:12 AM
|
|||
|
|||
|
Yes you can do that. While I can't help you with the specifics because I use the USB-UIRT to control by GI C band 4DTV receiver, with the proper gml file you can do everything you want to do.
Mine is setup to control SageTV and also the 4DTV receiver, probably more complex than your setup is. So it'll do it. You will need Girder in order to do this however, or a simple means would be to program it via the Sage Interface where you select it. I'd try that first as girder is not free and you already have the other.
|
|
#3
06-05-2006, 08:37 AM
|
||||
|
||||
|
If you don't see the USB-UIRT listed as a Tuning Plugin option for controlling an external receiver, then double check that the USB-UIRT drivers are installed. Perhaps check to see if the USB-UIRT works as a receiver in SageTV in Detailed Setup -> Commands -> Remote Control Config.
- Andy
__________________
SageTV Open Source v9 is available. - Read the SageTV FAQ. Older PDF User's Guides mostly still apply: SageTV V7.0 & SageTV Studio v7.1. - Hauppauge remote help: 1) Basics/Extending it 2) Replace it 3) Use it w/o needing focus - HD Extenders: A) FAQs B) URC MX-700 remote setup Note: This is a users' forum; see the Rules. For official tech support fill out a Support Request.
|
|
#5
06-05-2006, 05:31 PM
|
||||
|
||||
|
The plugin should be installed when SageTV is installed. Maybe someone else can comment on that part.
But, the USB-UIRT is on the server PC, correct? A client can only use it as a receiver. - Andy
__________________
SageTV Open Source v9 is available. - Read the SageTV FAQ. Older PDF User's Guides mostly still apply: SageTV V7.0 & SageTV Studio v7.1. - Hauppauge remote help: 1) Basics/Extending it 2) Replace it 3) Use it w/o needing focus - HD Extenders: A) FAQs B) URC MX-700 remote setup Note: This is a users' forum; see the Rules. For official tech support fill out a Support Request.
|
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Linear Mode
