|
|
|||||||
| Hardware Support Discussions related to using various hardware setups with SageTV products. Anything relating to capture cards, remotes, infrared receivers/transmitters, system compatibility or other hardware related problems or suggestions should be posted here. |
 |
|
|
Thread Tools | Search this Thread | Display Modes |
|
#1
04-24-2006, 04:36 PM
|
|||
|
|||
|
No signal on PVR 150
hey everyone
I got thepvr 150 sage package a few weeks back but right when i downloaded the sage software i had to rush out and buy a wintv to go which worked fine. When my pvr 150 arrived in the mail from sage, I installed it and ran the cable wire into both cards. I reinstalled sage and setup the new source but the channel search only gave me snow on the screen as if the cable was not connected. I switched wires to see if there was a problem there, but i still got a signal on my wintv to go and not my pvr-150. Could there be a problem with the card itself? 
|
|
#2
04-24-2006, 05:37 PM
|
|||
|
|||
|
Didn't see this before, but it seems like someone had the same problem as I but don't see any solution...Other Thread
|
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Linear Mode
