|
|
|||||||
| SageTV Software Discussion related to the SageTV application produced by SageTV. Questions, issues, problems, suggestions, etc. relating to the SageTV software application should be posted here. (Check the descriptions of the other forums; all hardware related questions go in the Hardware Support forum, etc. And, post in the customizations forum instead if any customizations are active.) |
 |
|
|
Thread Tools | Search this Thread | Display Modes |
|
#1
03-20-2006, 11:57 PM
|
|||
|
|||
|
Minor "com port" bug in Sage Setup
I found another bug in the Sage setup. Once you have configured a video source to use a specific com port to change channels on the STB, if you then go back to look at it then there are two problems. First - you can't see what com port the video source is using. Mine says the following:
Tuner Control: C:\Program Files\SageTV\Common\DirecTVSerialContr... Since it runs out of room - you would think you could click it to view the Com port and allow to change it. If you click it, it does not show the com port. Rather, it goes to an IR menu. But, I'm not using an IR control so why does it go there? Thanks, Mike 
|
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Linear Mode
