|
|
|||||||
| Hardware Support Discussions related to using various hardware setups with SageTV products. Anything relating to capture cards, remotes, infrared receivers/transmitters, system compatibility or other hardware related problems or suggestions should be posted here. |
 |
|
|
Thread Tools | Search this Thread | Display Modes |
|
#1
03-09-2006, 10:25 PM
|
||||
|
||||
|
Need help want to use sage tv and windows media center
I have a media pc 2005 version. I use dish network with it. I wanted to use my other comcast service hookup with the same pc with sagetv going through the same card. I wanted to have sage open during the day recording some things I don't get on dish then close it at night for dish. The trouble is I know it's working as I can see comcast in Mc2005. I don't load the settings because that one is set up for Dish. When I load sage it says There was a capture error in playback error -2,080040207 problem using a sage tv component. I figure something with MC is still opn but am not sure what. The dish is using svid while the other is using tv input
Last edited by gav; 03-09-2006 at 10:28 PM. 
|
|
#2
03-09-2006, 11:25 PM
|
||||
|
||||
|
__________________
SageTV Open Source v9 is available. - Read the SageTV FAQ. Older PDF User's Guides mostly still apply: SageTV V7.0 & SageTV Studio v7.1. - Hauppauge remote help: 1) Basics/Extending it 2) Replace it 3) Use it w/o needing focus - HD Extenders: A) FAQs B) URC MX-700 remote setup Note: This is a users' forum; see the Rules. For official tech support fill out a Support Request.
|
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Linear Mode
