|
|
|||||||
| SageTV Linux Discussion related to the SageTV Media Center for Linux. Questions, issues, problems, suggestions, etc. relating to the SageTV Linux should be posted here. |
 |
|
|
Thread Tools | Search this Thread | Display Modes |
|
#1
02-23-2006, 05:55 PM
|
||||
|
||||
|
Can't save remote codes?
Has anyone had a problem trying to save remote codes when using an MVP? If I change any code for the TV button or for the Previous Channel button, it does not stick when I restart Sage.
Most other buttons save, but these don't seem to. Lauren 
|
|
#2
02-23-2006, 06:05 PM
|
||||
|
||||
|
How soon are you shutting off the MVP when you link codes? See if going to & then exiting the Config Wiz menu fixes it, since the properties are forced to be saved when leaving that menu.
- Andy
__________________
SageTV Open Source v9 is available. - Read the SageTV FAQ. Older PDF User's Guides mostly still apply: SageTV V7.0 & SageTV Studio v7.1. - Hauppauge remote help: 1) Basics/Extending it 2) Replace it 3) Use it w/o needing focus - HD Extenders: A) FAQs B) URC MX-700 remote setup Note: This is a users' forum; see the Rules. For official tech support fill out a Support Request.
|
|
#3
02-23-2006, 06:38 PM
|
||||
|
||||
|
Quote:
I even added a SaveProperties() command to the STV, and it still has the same problem. If I map the TV button to SageRecordings, it will remember it, but if I hit Control-C to exit Sage, later on it won't remember it. Lauren
|
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Linear Mode
