|
|
|||||||
| Hardware Support Discussions related to using various hardware setups with SageTV products. Anything relating to capture cards, remotes, infrared receivers/transmitters, system compatibility or other hardware related problems or suggestions should be posted here. |
 |
|
|
Thread Tools | Search this Thread | Display Modes |
|
#1
02-23-2006, 08:51 AM
|
||||
|
||||
|
Using SageTV with a cable box
Is there a way to make SageTV tune independantly when the signal comes from a cable box? Before I had a splitter with one line going to my television and one going to my Hauppauge 150. That way I could record a different channel with Sage and watch something else on my television. Now, SageTV only tunes in whatever I have on the cable box, so this means I have to watch whatever I want to record. I'm using an S-video cable from my cable box to my Hauppauge. Any help would be much appreciated!
|
|
#2
02-23-2006, 12:09 PM
|
||||
|
||||
|
If you are recording the output from a converter box, there is no way to tune to something other than what the box is currently tuned to -- the box only decodes & outputs one channel at a time.
The capture card can do the tuning for a direct analog coax connection, because the coax is carrying all the channels. - Andy
__________________
SageTV Open Source v9 is available. - Read the SageTV FAQ. Older PDF User's Guides mostly still apply: SageTV V7.0 & SageTV Studio v7.1. - Hauppauge remote help: 1) Basics/Extending it 2) Replace it 3) Use it w/o needing focus - HD Extenders: A) FAQs B) URC MX-700 remote setup Note: This is a users' forum; see the Rules. For official tech support fill out a Support Request.
|
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Linear Mode
