|
|
|||||||
| SageTV Software Discussion related to the SageTV application produced by SageTV. Questions, issues, problems, suggestions, etc. relating to the SageTV software application should be posted here. (Check the descriptions of the other forums; all hardware related questions go in the Hardware Support forum, etc. And, post in the customizations forum instead if any customizations are active.) |
 |
|
|
Thread Tools | Search this Thread | Display Modes |
|
#1
01-20-2006, 09:05 AM
|
|||
|
|||
|
Red status bar on recording
I had a recording cut off with 1 minute left in the show. The recording status bar at the bottom had a large red line terminating the green bar. I started deleting things from the disk assuming it was a dispace issue, but I never checked that assumption before I started deleting. Does that thick read bar mean it has run out of space?
__________________
Software: Sage v4.1, Girder v3.3, Windows XP, AC3Filter, IRTrans, WinAmp The Goods: Hauppauge 500 MCE, Gigabyte nVIDIA GeForce 6600 GT SLI, Asus A8N-E, AMD 64 3200+ "Venice", 1Gig DDR 400, HP dvd740i, Seasonic 12 330, OrigenAE X11, Windows MCE remote, Duct tape 
|
|
#2
01-20-2006, 10:55 AM
|
||||
|
||||
|
To me the red line terminating the green bar means that it was supposed to be recorded but wasn't. Do you have some show with a start padding that maybe cut into it? Signal loss from the antenna or cable?
|
|
#3
01-20-2006, 02:18 PM
|
||||
|
||||
|
Right -- the red bar just means it is a section of the show that didn't get recorded; see p. 112 in the v4.1 manual for all the various colors. It could have been missed for a variety of reasons, so it doesn't indicate any one problem.
- Andy
__________________
SageTV Open Source v9 is available. - Read the SageTV FAQ. Older PDF User's Guides mostly still apply: SageTV V7.0 & SageTV Studio v7.1. - Hauppauge remote help: 1) Basics/Extending it 2) Replace it 3) Use it w/o needing focus - HD Extenders: A) FAQs B) URC MX-700 remote setup Note: This is a users' forum; see the Rules. For official tech support fill out a Support Request.
|
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Linear Mode
