|
|
|||||||
| Hardware Support Discussions related to using various hardware setups with SageTV products. Anything relating to capture cards, remotes, infrared receivers/transmitters, system compatibility or other hardware related problems or suggestions should be posted here. |
 |
|
|
Thread Tools | Search this Thread | Display Modes |
|
#1
12-28-2005, 11:47 PM
|
|||
|
|||
|
DigiVox DVB-T USB
I have an 866MHz Pentium III and I tried to run Sage TV in the hope it would use fewer resources than the software that came with the DIGIVOX DVB-T USB-2.0 unit. On loading SAGETV, it seemed to expect a Haupage card. Is there a trick to getting a different USB TV receiver unit to work? The DigiVox is "MCE compatible" but I'm running Windows XP PRO. Minimum recommended system for the DigiVox is 800MHz PIII.
|
|
#2
12-29-2005, 02:20 AM
|
|||
|
|||
|
Sage does not have native support for DVB. you can try the network encoder found here: http://forums.sage.tv/forums/showthread.php?t=11193 or the MyTheatre support from here: http://forums.sage.tv/forums/showthread.php?t=12473
If you live in England you should wait for the next version of SBDRARecorder that will have better support for scanning channels. Anders
|
|
#3
12-29-2005, 05:16 AM
|
|||
|
|||
|
Using the DigiVOX
Thanks. I'll look it up and see if I can figure it out. I'm in Northern Australia. Hot and humid despite being 9:15 PM. I'm fairly sure we have the same TV system as the UK but I'm not sure of bandwidth/frequency range.
|
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Linear Mode
