|
|
|||||||
| Hardware Support Discussions related to using various hardware setups with SageTV products. Anything relating to capture cards, remotes, infrared receivers/transmitters, system compatibility or other hardware related problems or suggestions should be posted here. |
 |
|
|
Thread Tools | Search this Thread | Display Modes |
|
#1
12-05-2005, 05:28 PM
|
|||
|
|||
|
d10-100 transponder
I'm having problems getting a good signal on my d10-100. My signal quality is around 50 and if i set the transponder to 18 i get 95. However, if i leave that screen it reverts to transponder 1, and my signal quality degrades back to 50. Any ideas?
|
|
#2
12-05-2005, 09:17 PM
|
|||
|
|||
|
Try very small adjustments to the dish. I believe if slightly off some transponders will come in fine and other won't. When I adjusted mine I fiddled around a bit by runing a cable to a small 13" TV I placed near the dish.
On my D10-100 when I go to the sattelite setup screen it show the signal strenghth on each transponder on the same screen. Is #1 the only one that is weak? That said, your variation seems very large, might be best to call DTV support. I recall I would have a 15% difference untill adjusted just right, I don't recall ever having a 45% difference.
|
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Linear Mode
