|
|
|||||||
| Hardware Support Discussions related to using various hardware setups with SageTV products. Anything relating to capture cards, remotes, infrared receivers/transmitters, system compatibility or other hardware related problems or suggestions should be posted here. |
 |
|
|
Thread Tools | Search this Thread | Display Modes |
|
#1
12-03-2005, 05:23 PM
|
|||
|
|||
|
channels not tuning correctly
last night i had a couple of scheduled recordings record the wrong channel. it seems that when sage goes and changes my channel for a recording it will only take the 1st 2 digits and i am stuck recording channel 11. is there some setting i can change to wait until all digits have been entered. i am using the pvr 150 IR blaster.
Thanks 
|
|
#2
12-09-2005, 09:41 AM
|
|||
|
|||
|
Have had the same issue. I have been tweeaking the settings under "Video Source -> Remote Control Options". I have been changing the Delay between codes and delay between channel changes. I have reduced both of these by half. I also have Confirm Code set to none.
Additionally, under "Setup -> Detailed Setup -> Customize" I set "always tune channel" to yes. Between each recording it will try to change to the desired channel. I am still tweaking the delays but this worked for 95% of my recordings.
|
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Linear Mode
