|
|
|||||||
| Hardware Support Discussions related to using various hardware setups with SageTV products. Anything relating to capture cards, remotes, infrared receivers/transmitters, system compatibility or other hardware related problems or suggestions should be posted here. |
 |
|
|
Thread Tools | Search this Thread | Display Modes |
|
#1
11-15-2005, 05:12 PM
|
|||
|
|||
|
IR blaster and Channel 3 Help
Well, I have been scanning all through these forums the last few days and have found people with similar issues but no real solution.
I have IR blaster working well within the software, however it does not work with the remote. The remote changes the channel within sage and that in turn changes the channel on the tv but not on the digital cable box, where I would like it to work. I see a setting within Sage after selecting video sources call RF Channel, which is N/A and I am unable to change it. Am I looking in the right spot? Any thoughts? Oh, before I forget Hauppauge 150, Sage V4.0, motorola box from comcast. Thanks, Jake 
|
|
#2
11-15-2005, 05:37 PM
|
||||
|
||||
|
How is the cable box conneced to the tuner card?
And, on the Source Details screen, what is the "Input Type"? If you are using a coax cable from the converter, then you would have to specify that you are using an external receiver to tune the channels (see p. 146 in the SageTV manual). If you didn't do that before, you may have to remove the source & reconfigure. - Andy
__________________
SageTV Open Source v9 is available. - Read the SageTV FAQ. Older PDF User's Guides mostly still apply: SageTV V7.0 & SageTV Studio v7.1. - Hauppauge remote help: 1) Basics/Extending it 2) Replace it 3) Use it w/o needing focus - HD Extenders: A) FAQs B) URC MX-700 remote setup Note: This is a users' forum; see the Rules. For official tech support fill out a Support Request.
|
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Linear Mode
