|
|
|||||||
| SageTV Software Discussion related to the SageTV application produced by SageTV. Questions, issues, problems, suggestions, etc. relating to the SageTV software application should be posted here. (Check the descriptions of the other forums; all hardware related questions go in the Hardware Support forum, etc. And, post in the customizations forum instead if any customizations are active.) |
 |
|
|
Thread Tools | Search this Thread | Display Modes |
|
#1
11-01-2005, 12:56 PM
|
|||
|
|||
|
live tv channel change
When I'm watching live tv and get to the end of the show, Sage would issue a channel change command for the same channel that I'm watching because it's technically a new show. This causes an audio stutter and is pretty much useless since I want to be watching the same channel. Is there any way to prevent this behavior?
Erwen 
|
|
#2
11-01-2005, 01:00 PM
|
||||
|
||||
|
That is controlled by the mmc/always_tune_channel property, but in v3 you can change it in Detailed Setup -> Customize. Look for the "Always tune channel" option.
- Andy
__________________
SageTV Open Source v9 is available. - Read the SageTV FAQ. Older PDF User's Guides mostly still apply: SageTV V7.0 & SageTV Studio v7.1. - Hauppauge remote help: 1) Basics/Extending it 2) Replace it 3) Use it w/o needing focus - HD Extenders: A) FAQs B) URC MX-700 remote setup Note: This is a users' forum; see the Rules. For official tech support fill out a Support Request.
|
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Linear Mode
