|
WinTV PVR-150 IR Blaster not found in config
I have a WinTV 250 and WinTV 150 (retail) in my system (pIII, 600mhz). All the drivers install fine for the PVR cards, and it has been working fine, including the IR receiver. But, I recently tried to setup the IR Blaster for my STB. However, the LED light stays on all the time (is this normal?), and when I go to the blaster config, it says that IR hardware is not found. I installed IRblast, and I have it in the correct PVR card (the 150 is the one that takes control of the IR - when using SageTV).
Without being able to setup in the blaster config, there is no way to set it up to work through Sage. Anyone come across this before? Thanks
Last edited by sabre; 10-30-2005 at 07:34 AM.
|
10-29-2005, 06:24 PM
Linear Mode
