|
|
|||||||
| SageTV Software Discussion related to the SageTV application produced by SageTV. Questions, issues, problems, suggestions, etc. relating to the SageTV software application should be posted here. (Check the descriptions of the other forums; all hardware related questions go in the Hardware Support forum, etc. And, post in the customizations forum instead if any customizations are active.) |
 |
|
|
Thread Tools | Search this Thread | Display Modes |
|
#1
10-19-2005, 01:05 PM
|
||||
|
||||
|
Converting from mapped drives to UNC
I want to enable the server and run it off my user login account.
Currently all my drives are mapped network drives. If I go and add the UNC equivalent to the videos directory, how do I convert the existing files to be UNC instead of mapped? Will I loose any info by converting? thanks, 
|
|
#2
10-19-2005, 01:56 PM
|
||||
|
||||
|
Check out this long & confusing FAQ.
It is possible to convert, but you should back up your config files & so on. Also, make sure the old mapped driver letter still is pointing to some enpty dir so that SageTV can see that the existing recordings are no longer in their old locations. Otherwise, it won't accept them at the new UNC paths. - Andy
__________________
SageTV Open Source v9 is available. - Read the SageTV FAQ. Older PDF User's Guides mostly still apply: SageTV V7.0 & SageTV Studio v7.1. - Hauppauge remote help: 1) Basics/Extending it 2) Replace it 3) Use it w/o needing focus - HD Extenders: A) FAQs B) URC MX-700 remote setup Note: This is a users' forum; see the Rules. For official tech support fill out a Support Request.
|
|
#3
10-19-2005, 02:28 PM
|
||||
|
||||
|
Ok, I tried this on the 3.0.13 beta and it just converted everything for me automagically!
Nice improvement, guess I should have posted this to that forum instead. thanks,
|
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Linear Mode
