|
|
|||||||
| Hardware Support Discussions related to using various hardware setups with SageTV products. Anything relating to capture cards, remotes, infrared receivers/transmitters, system compatibility or other hardware related problems or suggestions should be posted here. |
 |
|
|
Thread Tools | Search this Thread | Display Modes |
|
#1
09-22-2005, 12:29 PM
|
|||
|
|||
|
UIRT not there in Sage
Ok sounds strange cause this worked before but I got a new HD and started all over.
UIRT is in my System Hardware but when setup in SageTV says it doesn't find it and make sure that it is recognize by windows. I have tired un-installing the drivers for UIRT rebooting and installing again. I tired uninstalling and installing SageTV again. Any ideas to make this work cause I am about to give up and move to MythTV or buy a stupid TiVO. Thanks 
|
|
#3
09-26-2005, 01:07 PM
|
||||
|
||||
|
In SageTV, the USB-UIRT doesn't work as a blaster, receiver, or both?
If using service mode, try using non-service mode to see if you can configure it that way. - Andy
__________________
SageTV Open Source v9 is available. - Read the SageTV FAQ. Older PDF User's Guides mostly still apply: SageTV V7.0 & SageTV Studio v7.1. - Hauppauge remote help: 1) Basics/Extending it 2) Replace it 3) Use it w/o needing focus - HD Extenders: A) FAQs B) URC MX-700 remote setup Note: This is a users' forum; see the Rules. For official tech support fill out a Support Request.
|
|
#4
09-27-2005, 01:49 AM
|
|||
|
|||
|
Not sure about how to do non- service and service mode, I will read the manuel on that to see whats up. I will try that out tomorrow afterwork.
After installing Sage and then going thour the setup I it will not see it as a blaster to tune my Cable STB.
|
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Linear Mode
