Hauppauge Remote Buttons

[andypoi]

Hi,

I'm using the remote that comes with the Hauppauge PVR-150 to control SageTV. Most of the buttons work, like channel up/down, volume, and number buttons. The arrows, however, won't work. Even when I go into the interface and try to link the buttons, the arrows will not register.

Anyone seen this before?

Thanks for the help.

[dvd_maniac]

Since it's the 150 remote I am guessing that it is the 45 button remote.
Here is something from Opus which will get you started in customizing your remote

[Opus4]

If you are using v2, you want to see post #3 in the above link.

If you are using v3, it has built-in support for that remote, if you choose to install that support when you install v3.

- Andy

[wheelrandolph]

Hi Andypoi,
I had the same problem for a while; make sure the irremote.ine file (in Windows dir) has a "SageTV" section all the way at the END. Also, if you are using Ver. 3, you have to remove "Frey Technologies" from the "Default" section and replace it with another "SageTv":


In the [Default] section, set:
GRNPOWER={run(C:\Progra~1\SageTV\SageTV\SageTV.exe)}{mode(SageTV)}

In the [SageTV] section, set:
GRNPOWER={ctrl}z{mode(Default)}

This may sound dumb but make sure you press "Green Power Button" to start everything; I was using the mouse and never pressed green button and it would NOT work.

Hope this helps.
Randy