|
|
|||||||
| Hardware Support Discussions related to using various hardware setups with SageTV products. Anything relating to capture cards, remotes, infrared receivers/transmitters, system compatibility or other hardware related problems or suggestions should be posted here. |
 |
|
|
Thread Tools | Search this Thread | Display Modes |
|
#1
08-23-2005, 03:04 PM
|
|||
|
|||
|
Any way to make Hauppauge IR Blaster to work with Girder
Hi
IS there any way to make the IR Blaster that comes with Hauppauge Wintv-PVR-150 to work with Girder? Does it work with Sagetv to control settop boxes for digital cable? thanks 
|
|
#2
08-23-2005, 03:38 PM
|
||||
|
||||
|
Maybe someone else will know about a Girder plugin for the blaster, but SageTV can use the blaster -- see p. 199 in the v2.2 PDF manual in you SageTV directory for a short blurb on it (end of Appendix F). It all depends on first configuring the blaster using the Hauppauge software, from what I understand.
- Andy
__________________
SageTV Open Source v9 is available. - Read the SageTV FAQ. Older PDF User's Guides mostly still apply: SageTV V7.0 & SageTV Studio v7.1. - Hauppauge remote help: 1) Basics/Extending it 2) Replace it 3) Use it w/o needing focus - HD Extenders: A) FAQs B) URC MX-700 remote setup Note: This is a users' forum; see the Rules. For official tech support fill out a Support Request.
|
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Linear Mode
