|
|
|||||||
| SageTV Software Discussion related to the SageTV application produced by SageTV. Questions, issues, problems, suggestions, etc. relating to the SageTV software application should be posted here. (Check the descriptions of the other forums; all hardware related questions go in the Hardware Support forum, etc. And, post in the customizations forum instead if any customizations are active.) |
 |
|
|
Thread Tools | Search this Thread | Display Modes |
|
#1
04-24-2005, 11:56 AM
|
||||
|
||||
|
way to do card preference?
Im running a dual tuner system with two PVR-150s One I have connected to a Motorola cable box via RCA out and the other to normal cable. When I originally set it up I installed the normal cable card first and then the motorola. The problem is that Sage is chooseing to change the cable box first and then the normal cable feed last. What I want it to do is use the normal feed first as long as its a channel it can record and then use the cable box feed for the higher channel or for the lower channels if its doing two recordings at the same time. is there any way I can get it to do this?
|
|
#2
04-24-2005, 12:09 PM
|
||||
|
||||
|
See the encoder_merit property mentioned in p. 180 of the v2.2 manual.
- Andy
__________________
SageTV Open Source v9 is available. - Read the SageTV FAQ. Older PDF User's Guides mostly still apply: SageTV V7.0 & SageTV Studio v7.1. - Hauppauge remote help: 1) Basics/Extending it 2) Replace it 3) Use it w/o needing focus - HD Extenders: A) FAQs B) URC MX-700 remote setup Note: This is a users' forum; see the Rules. For official tech support fill out a Support Request.
|
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Linear Mode
