|
|
|||||||
| Hardware Support Discussions related to using various hardware setups with SageTV products. Anything relating to capture cards, remotes, infrared receivers/transmitters, system compatibility or other hardware related problems or suggestions should be posted here. |
 |
|
|
Thread Tools | Search this Thread | Display Modes |
|
#1
04-12-2005, 04:27 PM
|
|||
|
|||
|
Hauppauge PVR-150MCE Low Profile
Hi There,
I desperately need a low profile pci encoder card Has anyone tried the Hauppauge WinTV PVR-150MCE l.p. ??? Does it work with sagetv? Can it be setup as a network encoder with sagerecorder? thanks. 
|
|
#2
04-12-2005, 07:42 PM
|
||||
|
||||
|
It should work fine with sageTV, other than the pcb layout and size there is no difference between it and the regular 150. However, unfortunately it will not work with SageRecorder, 150/500 support was never added. If you have two SageTV full installs, one as your server and one as the client, with two individual license keys, you can run it as you desire.
With the two full SageTV installs you can share your client cards with the sageTV server and connect to the server in client mode.
|
|
#3
04-13-2005, 08:42 AM
|
|||
|
|||
|
two full SageTV installs
Thankyou very much.
I've purchased SageTV, SageTV Client, and SageRV Recorder. I hadn't heard about using two full SageTV installs. Will this setup utilize all the tuners in both systems? will the recording schedule be shared between the machines? Thanks.
|
|
#5
04-13-2005, 10:04 AM
|
||||
|
||||
|
__________________
SageTV Open Source v9 is available. - Read the SageTV FAQ. Older PDF User's Guides mostly still apply: SageTV V7.0 & SageTV Studio v7.1. - Hauppauge remote help: 1) Basics/Extending it 2) Replace it 3) Use it w/o needing focus - HD Extenders: A) FAQs B) URC MX-700 remote setup Note: This is a users' forum; see the Rules. For official tech support fill out a Support Request.
|
|
#7
05-09-2005, 11:44 PM
|
|||
|
|||
|
Network Encoder Help
Ok maybe this is obvious but it hadn't occured to me and I hadn't seen it in the instructions.
To get the network encoder to work at all, both versions of sageTV must be exactly the same. I had tried 2.2.7 with 2.2.8 and couldn't get the two pcs to communicate. I could see a "TIME_WAIT" status using netstat -a on the second pc but it never successfully connected until I upgraded my main install of SageTV to 2.2.8 Now I have a functional network encoder on pc #2 that is being used by pc #1. The problem is sageTV on pc#2 shows no recordings or scheduled recordings. Is there a setting I'm missing to have sagetv on pc#2 act as a client to pc#1???? thanks. Last edited by backsix; 05-12-2005 at 10:26 AM.
|
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Linear Mode
