|
SageTV Software Discussion related to the SageTV application produced by SageTV. Questions, issues, problems, suggestions, etc. relating to the SageTV software application should be posted here. (Check the descriptions of the other forums; all hardware related questions go in the Hardware Support forum, etc. And, post in the customizations forum instead if any customizations are active.) |
|
Thread Tools | Search this Thread | Display Modes |
#1
|
|||
|
|||
help! sagetv only records channel 4!
Suddenly all I get are recordings of channel 4.
The recording schedule shows the right channels, and the "Detailed Info" on all of my recordings reflect the information on the show it was supposed to record, but when I play them all, they are all recordings of channel 4 from the time it was supposed to record another show. Any ideas? P-III 866 MHz, 448 MB RAM Capture device: Hauppauge WINTV-PVR-150, connected to cable by coax Video card: ATI Radeon 9200 |
#2
|
||||
|
||||
Are you using an external cable box? If so perhaps the channel isn't getting changed for some reason. I had this same problem with my directv receiver, turned out to be a bad serial connection.
|
#3
|
|||
|
|||
nope, no cable box. the coax goes from the wall to a splitter. One side of the splitter goes to the cable modem and the other side goes to the Hauppauge card.
If I reboot my computer then Sage switches the channels like it should for a while, but at some point it gets stuck on channel 4... and I don't even watch channel 4! |
#4
|
||||
|
||||
Just a few guesses:
__________________
SageTV Open Source v9 is available. - Read the SageTV FAQ. Older PDF User's Guides mostly still apply: SageTV V7.0 & SageTV Studio v7.1. - Hauppauge remote help: 1) Basics/Extending it 2) Replace it 3) Use it w/o needing focus - HD Extenders: A) FAQs B) URC MX-700 remote setup Note: This is a users' forum; see the Rules. For official tech support fill out a Support Request. |
#5
|
|||
|
|||
This is weird. I had two scheduled recordings back to back on the same channel (channel 66) - one program from 8 to 9, and one from 9 to 10. It recorded the correct show from 8-9 and then at 9 changed to channel 4, even though the display indicated channel 66 and showed the program info for the show that was on channel 66.
I think I might just reinstall SageTV tomorrow. Is there a quick way to backup my favorites (not the actual recordings, just the list of shows that I want to record)? |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|