|
|
|||||||
| SageTV Software Discussion related to the SageTV application produced by SageTV. Questions, issues, problems, suggestions, etc. relating to the SageTV software application should be posted here. (Check the descriptions of the other forums; all hardware related questions go in the Hardware Support forum, etc. And, post in the customizations forum instead if any customizations are active.) |
 |
|
|
Thread Tools | Search this Thread | Display Modes |
|
#1
03-15-2005, 11:11 PM
|
|||
|
|||
|
Video storage on mapped drives
My Hauppauge 350 eats disk space. Is there some reason why I cannot use a mapped drive for additional storage? I would like to distribute my files around because amongst my 10 or so machines I have over a terabyte - only 300 megs on my main computer though.
Right now SageTV doesn't seem to like them. 
|
|
#2
03-15-2005, 11:30 PM
|
||||
|
||||
|
Are you using service mode? Services can't access mapped drives. See the bottom of p. 14 in the v2.2 manual. (You can use UNC paths instead, but the service has to log in as a user w/a password.)
- Andy
__________________
SageTV Open Source v9 is available. - Read the SageTV FAQ. Older PDF User's Guides mostly still apply: SageTV V7.0 & SageTV Studio v7.1. - Hauppauge remote help: 1) Basics/Extending it 2) Replace it 3) Use it w/o needing focus - HD Extenders: A) FAQs B) URC MX-700 remote setup Note: This is a users' forum; see the Rules. For official tech support fill out a Support Request.
|
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Linear Mode
