|
|
|||||||
| Hardware Support Discussions related to using various hardware setups with SageTV products. Anything relating to capture cards, remotes, infrared receivers/transmitters, system compatibility or other hardware related problems or suggestions should be posted here. |
 |
|
|
Thread Tools | Search this Thread | Display Modes |
|
#1
03-10-2005, 03:47 AM
|
|||
|
|||
|
Hauppauge ir blaster weird problem
Ok, so I have a 150 and thanks to the great info in this forum had everything working perfectly until I switched from tuner to composite. Now whenever I change channels it only picks up two of the three numbers. I used the blastcfg utility for hauppauge and it works fine when I test it through there. Any ideas.
Thanks 
|
|
#2
03-10-2005, 09:29 AM
|
||||
|
||||
|
Is its config set to use a max of 2-digit channels somewhere?
For other IR transmistters, there is an option for digits per channel in Source Details -> Tuner Control -> Remote Control Options, but for the Hauppauge blaster all of that may still be in the Hauppauge config utility. That's the only idea I have... and it might not have anything to do with your problem. - Andy
__________________
SageTV Open Source v9 is available. - Read the SageTV FAQ. Older PDF User's Guides mostly still apply: SageTV V7.0 & SageTV Studio v7.1. - Hauppauge remote help: 1) Basics/Extending it 2) Replace it 3) Use it w/o needing focus - HD Extenders: A) FAQs B) URC MX-700 remote setup Note: This is a users' forum; see the Rules. For official tech support fill out a Support Request.
|
|
#3
03-10-2005, 08:28 PM
|
|||
|
|||
|
whoops
Didn't consider the fact that I had moved the computer closer to the ir blaster and the hauppauge controller was interfering with the blaster. Built it a house, all better now. Thanks
|
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Linear Mode
