|
|
|||||||
| SageTV Software Discussion related to the SageTV application produced by SageTV. Questions, issues, problems, suggestions, etc. relating to the SageTV software application should be posted here. (Check the descriptions of the other forums; all hardware related questions go in the Hardware Support forum, etc. And, post in the customizations forum instead if any customizations are active.) |
 |
|
|
Thread Tools | Search this Thread | Display Modes |
|
#1
03-09-2005, 07:59 AM
|
|||
|
|||
|
Channel Changes - number of digits?
Not sure where to place this query, but here goes...
I do not have a cable box and have the cable coax going directly into my 350PVR card. I want to set the software up so that I only have to enter 2 digits on the Hauppauge remote before it switches channels - right now I seem to have to enter 3 (e.g. 021 instead of just 21). I don't have any channels above 100, so I don't need 3 digits. I don't know if this is a sage paramater or a Hauppauge irremote.ini parameter....any thoughts? Thanks, Tom 
|
|
#2
03-09-2005, 10:18 AM
|
||||
|
||||
|
I believe this (max possible channel) is something that SageTV determines automatically. It probably sees that the tuner can go into 3-digit channels or there is a higher channel that exists, but is disabled. It seems like the request here would be to have the max channel determined only from those in use, but I don't know if that could affect something else.
- Andy
__________________
SageTV Open Source v9 is available. - Read the SageTV FAQ. Older PDF User's Guides mostly still apply: SageTV V7.0 & SageTV Studio v7.1. - Hauppauge remote help: 1) Basics/Extending it 2) Replace it 3) Use it w/o needing focus - HD Extenders: A) FAQs B) URC MX-700 remote setup Note: This is a users' forum; see the Rules. For official tech support fill out a Support Request.
|
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Linear Mode
