|
|
|||||||
| SageTV Beta Test Software Discussion related to BETA Releases of the SageTV application produced by SageTV. Questions, issues, problems, suggestions, etc. regarding SageTV Beta Releases should be posted here. |
 |
|
|
Thread Tools | Search this Thread | Display Modes |
|
#1
02-05-2005, 11:08 PM
|
|||
|
|||
|
client or regular startup with beta?
not sure if this should be here, but I am using the 2.2.5 beta and have sage starting as a service.
I am a bit of a newb to sage but I though if I ran the service I had to run sage with the -client switch? I can run sage normally or as the client but is there a difference? does the new beta switch to the correct mode? I ask this as I thought it was "impossible" to run regular sage and the sage service on the same computer. 
|
|
#2
02-05-2005, 11:17 PM
|
|||
|
|||
|
when running the service
the "regular" sageTV that loads is basically a client edition
|
|
#3
02-06-2005, 12:20 AM
|
||||
|
||||
|
... and the UI will load automatically as a client of the service; no need to set a command line parameter. Check "Starting SageTV", beginning on p. 13 in the v2.1 manual that is in your SageTV dir. Maybe that will clear it up a bit... or maybe not.
- Andy
__________________
SageTV Open Source v9 is available. - Read the SageTV FAQ. Older PDF User's Guides mostly still apply: SageTV V7.0 & SageTV Studio v7.1. - Hauppauge remote help: 1) Basics/Extending it 2) Replace it 3) Use it w/o needing focus - HD Extenders: A) FAQs B) URC MX-700 remote setup Note: This is a users' forum; see the Rules. For official tech support fill out a Support Request.
|
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Linear Mode
